Canon XEED SX6000 - Manual (Page 80)

80
Turning Off the Projector
1
Press the POWER button to display the window shown below.
When this window is displayed, press the POWER button again to turn off the power.
The lamp goes off, the [STAND BY] indicator starts flashing in red and the cooling
process starts.
2
Disconnect the power cord from the electrical outlet.
If the power plug is left connected, the [STAND BY] indicator will switch from flashing
to constantly illuminated after the cooling process is completed.
• You cannot turn the projector on while the cooling process is in operation.
• If you want to continue projecting without turning off the power, press a button other than
POWER, or else wait until the confirmation message disappears.
• After turning off the projector, wait at least 5 minutes before turning it on again. It may shorten
the lamp life if you turn on the projector immediately after turning it off.
• Using the projector for a long time may shorten the life of the lamp and internal optical
components.
Remote control Projector Remote control