HP StorageWorks MSA 2.8 SAN Switch - Manual (Page 17)

Initial Configuration
17 Fabric OS Procedures Version 3.1.x/4.1.x User Guide
— Ethernet Subnetmask
— Hostname
— Gateway IP Address
2. Log in to the switch as the admin user.
3. Enter the ipaddrset command at the command line. An interactive
session is opened.
4. Choose the CP that you want to configure. Enter the value that corresponds to
that logical region:
— Enter 2 to configure CP 0 (slot 5).
— Enter 3 to configure CP 1 (slot 6).
5. Enter the Ethernet IP Address when prompted. Click Enter.
6. Enter the Ethernet Subnetmask when prompted. Click Enter.
7. Enter the Hostname when prompted. Click Enter.
8. Enter the Gateway IP Address when prompted. Click Enter.
9. Enter the ippaddrshow command to verify the data you entered, and exit.
10. Enter the hafailover command to make the second CP active.
11. Repeat steps 1 through 9 to configure the second CP.
12. See “ Configuring a Logical Switch IP Address for the Core Switch 2/64 ” to
configure the logical switch IP addresses.