HP XP Data Shredder Software User Manual
Page 35
Description
Item
Select an LDKC number from this list. The default is 00. The
settings of LDEV numbers for the selected LDKC and CU
numbers appear in the table on the left.
•
For an open-systems volume, you can select only 00.
•
For mainframe volumes of the following emulation types,
you must not select 01:
◦ 3380-n, where n is a letter, a number, or a
combination of both. However, you can select 01 if
the emulation type is 3380-3, 3380-3A, 3380-3B,
or 3380-3C.
◦ NF80-n, where n is a letter, a number, or a
combination of both.
Select LDKC No.
Select a CU number from this list. The default is CU 00. The
settings of LDEV numbers for the selected CU number
appear in the table on the left.
Select CU No.
When you select more than one volume, use this list to set
the interval between the LDEV numbers that need to be
assigned to the newly created volumes. The default value
is 0. When you select 0, the LDEV numbers will be assigned
consecutively.
The value you specify as the interval between LDEV
numbers counts only the available LDEV numbers and skips
those that are not selectable.
Interval
The settings of LDEV numbers for the CU number selected
from the Select CU No. list.
•
Gray indicates the LDEV numbers that are not selectable.
•
White indicates unused LDEV numbers.
•
Blue indicates available LDEV numbers.
You can select an LDEV number from the white LDEV
numbers in the table. When you set the LDEV number, that
LDEV number becomes available and changes to blue.
LDEV numbers that are not selectable may be already in
use or already assigned to another emulation group
(grouped by 32 LDEV numbers) (see
).
Select LDEV No.
When this check box is selected, you can select the number
of an LDEV that does not exist in the storage administrator
logical partition (SLPR) to which the parity group does not
belong. When the check box is cleared, you can only select
the number of the LDEV in the SLPR to which the parity
group belongs.
This check box can be selected only when logged in as a
storage administrator, and when there are two or more
SLPRs.
CU number of another SLPR is used
Returns to the Install CV dialog box (1).
Back
Opens one of the following dialog boxes:
•
If the boundary area of the selected LDEV number does
not have an SSID, the Install CV (Set SSID) dialog box
opens.
•
If the boundary area of the selected LDEV number has
an SSID, the Install CV confirmation dialog box opens.
Next
Install CV Dialog Box (2)
35