HP Storage Mirroring Software - Manual (Page 208)

Workload protection Page 207 of 677
Full-server ports
By default, Storage Mirroring Recover uses port 6320 for all TCP and UDP
communications. To verify or modify the ports, you must use the Replication Console.
1. Open the Replication Console .
2. Locate your servers in the server tree in the left pane of the Replication Console.
3. Right-click the server in the left pane of the Replication Console and select
Properties.
4. On the Network tab, verify or modify the Communications Port as needed. All
servers and clients in your full-server workload protection must be using the same
port.
Storage Mirroring Recover uses ICMP pings to monitor the source for failover. A failover
monitor will not be created if ICMP is blocked (although the data and system state will
still be protected). You should configure your hardware to allow ICMP pings between the
source and target. If you cannot, you will have to monitor for a failure using the Storage
Mirroring Recover replication service. Use the Monitor Type option on the configuration
Failover tab to
set your failover monitoring method .