HP Storage Mirroring Software - Manual (Page 373)

Workload monitoring Page 372 of 677
l
Restoring—Data is being restored from the target to the source
l
Unknown—The mirror status could not be determined
Mirror Remaining
The percentage of the mirror remaining
Replication Status
l
Replicating—Data is being replicated to the target machine
l
Ready—There is no data to replicate to the target machine
l
Stopped—Replication has stopped
l
Out of Memory—Kernel memory has been exhausted
Transmit Mode
l
Started—Data is being transferred to the target machine
l
Paused—Data transmission has been paused
l
Stopped—Data is not being transferred to the target machine.
l
Error—There is a transmission error.
Target State
l
Online—The target is active and online
l
Mirroring—The target is in the middle of a mirror process. The data will
not be in a good state until the mirror is complete.
l
Mirroring stopped—The mirroring process has been stopped
l
Remirror required—The data on the target is not in a good state
because a remirror is required. This may be caused by an incomplete
or stopped mirror or an operation may have been dropped on the target.
l
Retrying—The target machine is retrying operations
l
Paused—The target machine has been paused
l
Pausing—The connection is pausing
l
Restore required—The data on the source and target do not match
because of a failover condition. Restore the data from the target back to
the source. If you want to discard the changes on the target, you can
remirror to resynchronize the source and target.
l
Replicating—Data is being replicated to the target
l
Snapshot reverted—The data on the source and target do not match
because a snapshot has been applied on the target. Restore the data
from the target back to the source. If you want to discard the changes on
the target, you can remirror to resynchronize the source and target.
l
Target path blocked—Target path blocking is enabled