HP Storage Mirroring Software - Manual (Page 250)

Workload protection Page 249 of 677
Configuring items to failover
If you are performing an identity failover , then you have already selected the Items to
Failover. Changing any of the Items to Failover on the Advanced tab will automatically
make the same change on the Failover tab Configure Identity Failover page.
However, if you are performing DNS failover, you may want to modify the items that you
are failing over using the instructions below.
1. Make sure you have a valid domain and servers specified, click Configure from
the main Application Manager page, and then select the Advanced tab.
Note: The fields on the Advanced tab will vary depending on the type of
application you are protecting. In addition, the fields will vary depending on
if you
launched Application Manager in standard or advanced mode.
2. The default selected items under Items to Failover will depend on the application
you are protecting. Enable or disable if you want to failover the source's server
name, file shares, and/or Active Directory host name.
Note: If your source and target are on different subnets, you should not failover the
IP address.
Exchange Note: Do not failover the Active Directory host name.
SQL Note: Do not failover the server name.
File Server Note: You cannot failover file shares from a parent to child domain.
3. Click OK to save the settings.