HP Storage Mirroring Software - Manual (Page 506)

Failback and restore Page 505 of 677
k. Also on the source, change the source name back to its original name and
reboot, or restart the Workstation, Server, and any other services you were
prompted to stop.
l. Once the source is back online, users can reconnect to the source.
13. Confirm the Replication Console is communicating with the source using the
original IP address.
a. Right-click the source and select Remove.
b. Depending on your configuration, the source may be automatically inserted
back into the Replication Console. If it is not, select Insert, Server. Specify
the source server and click OK.
14. At this time, you can go back to the dialog box in the Failover Control Center.
Select Continue or Stop to indicate if you want to continue monitoring the source.
After you have selected whether or not to continue monitoring the source, the
source post-failback script, if configured, will be started.
Note: The source must be online and Storage Mirroring Recover must be running
to ensure that the source post-failback script can be started. If the source
has not completed its boot process, the command to start the script may be
lost and the script will not be initiated.
15. If desired, you can reconnect your original replication set on the source to your
target to reestablish protection.