HP 3PAR Application Software Suite for Microsoft Exchange Licenses - Manual (Page 96)

Table 6 HP 3PAR Recovery Manager Software for Microsoft Exchange Event Messages (continued)
Description/Action Error Message Event ID
The mailbox database is spread across multiple HP 3PAR Storage
Systems.
•
The database or log target volume must belong to a single HP 3PAR
Storage System. Refer to the preferred configuration setup.
RME5124: ERROR: Your
database is spread across
multiple InServs on the
production server. Please move
the Mailbox Database to only 5124
one InServ and perform this
operation again.
Failed to save the information to the configuration file.
•
Check that you have the correct permissions to the RMExchange
Repository
directory.
RME3126: ERROR: Could not
delete the local configuration
file. 3126
The Exchange server cannot determine which specific mailbox databases
to set up as the current range is too wide.
•
Unregister all mailbox databases and then register only the desired
databases one by one.
RME5148: ERROR: The
Exchange server is set to include
all Mailbox Databases. Please
remove this umbrella to register
individual Mailbox Databases. 5148
The specified zip file already exists.
•
Change the zip file name or delete the existing zip file.
RME3150: ERROR: The zip file
already exists. 3150
An invalid file name format was specified for the zip file.
• Check the syntax for the zip file name specified by the RMExch
report
command.
RME3151: ERROR: The filename
must end with .zip. 3151
The mailbox database name is missing from the RMExch command
syntax.
•
The mailbox database name must be included in the CLI command
parameters.
RME5154: ERROR: Missing
Mailbox Database name. 5154
The number of virtual copies is out of the range specified by the current
policy.
•
Reduce the number of virtual copies for this procedure or modify the
policy by raising the maximum number of virtual copies allowed.
RME3157: ERROR: Number of
virtual copies need to be in the
range of 1 to <Max. Count>. 3157
An invalid parameter was specified for the RMExch policy command.
Check the syntax for the RMExch policy command for the correct
parameters. RME3158: ERROR: Invalid
parameter entered for policy
command. 3158
96 Event Messages