HP 3PAR Application Software Suite for Microsoft Exchange Licenses User Manual
Page 97
Table 6 HP 3PAR Recovery Manager Software for Microsoft Exchange Event Messages (continued)
Description/Action
Error Message
Event ID
A conflict was detected regarding the specified repository relocation
path.
•
Verify the path given for repository relocation.
RME3164: ERROR: There is a
conflict with the specified path
for repository relocation.
3164
A copy process was not completed due to the status of the mailbox
database.
•
Check the mailbox database status. Get it into a Healthy state and
then try to create a copy.
RME5160: ERROR: The
replication status of a Mailbox
Database is '<Status>'. A copy
of unhealthy Mailbox Database
cannot be made.
5160
Virtual copy creation could not be completed due to a possible database
dismount in the associated mailbox database.
•
Mount all the databases in the mailbox database and try to create
the virtual copy.
RME5167: ERROR: One of the
databases in the Mailbox
Database may be dismounted,
cannot continue with Virtual
Copy creation.
5167
The specified virtual copy could not be located in the repository.
•
Check the syntax for the RMExch backup command.
RME3173: ERROR: The Virtual
Copy is not found in the
repository, check if parameters
are correct.
3173
A verification error for the snapshot operation occurred.
•
Run RMExch validate to verify that the snapshot was created.
RME3176: ERROR: Verification
has encountered an error.
Please run Validate command
on this snapshot.
3176
An error occurred during the backup.
•
Check the RMExch backup command parameters to ensure that
the correct policy name is used.
RME3198: ERROR: Backup
error occurred. Check to see if
your policy name is correct.
3198
The Symantec NetBackup process has generated an error.
RME3200: ERROR: NetBackup
process has failed with error
3200
•
Verify that NetBackup is installed properly and verify that the bin
subfolder is specified in the PATH environment variable.
code <Error Code>. Check if
NetBackup is included in
•
Refer to NetBackup documentation for information on the error code.
environment variable "PATH".
Consult NetBackup manual for
this error code.
97