HP Integrity NonStop H-Series - Manual (Page 18)

Product Overview
9840 (CT9840FC-3) Installation and User’s Guide for the NonStop S-Series Enclosure— 524959-003
1 -8
Operator Panel Indicators
Operator Panel Indicators
Operator Panel Display
The operator panel display is a single-line, 10-character alphanumeric display,
linked to the drive and to the host. The drive uses the display to indicate the
state of the drive, to show fault symptom codes when applicable, and to show
the menu selections and configurations states when the drive is in Menu mode.
Messages can be stable or blinking. Two messages can alternate. Appendix A,
Troubleshooting lists operator panel messages and their meanings.
Table 1-5. Operator Panel Indicators
Name Status Description
Power (green) Off Power is off.
Flashing Unit is not functional (powering on or
collecting dump).
Flashing does not
stop IPL failed.
Constantly on Power on and IPL have executed properly.
Activity (green) Off Cartridge is not loaded or ejected.
Flashing Tape motion is in progress.
When constantly
ON Tape is loaded. Drive is ready; unit is
operational.
Clean (Amber) Constantly ON Drive requires cleaning.
Indicator activated
for any of these
reasons 1. Certain intermittent media errors were
detected.
2. A preset length of tape passed over
the read/write heads.
Service (Red) Off No error was detected.
Flashing Contact (Global Customer Support Center)
GCSC.
ON A hardware error was detected, and drive
is not functional. The operator cannot
ignore a constant indicator. If an IPL does
not eliminate the problem, replace the
drive.