HP Integrity NonStop H-Series - Manual (Page 51)

9840 (CT9840FC-3) Installation and User’s Guide for the NonStop S-Series Enclosure— 524959-003
6 -1
6
Servicing the Tape Drive
This section includes:
Removing a Tape Drive From the Tape
Enclosure
1. Remove the rear cover.
2. Remove the power cord and the fiber cable from the unit.
3. Loosen the two screws on the rear of the drive. See Figure 6-2 on page 6-3 for the
location of the two rear screws.
4. When the two screws are both unscrewed all the way, take hold of the rear handle
and slowly pull the drive toward you.
5. Pull the tape drive out enough so that the top handle is visible. With one hand on
the rear handle and the other hand on the top handle, slowly pull the tape drive out
of the enclosure and set it aside.
Removing a Tape Drive From the Tape
Enclosure 6-1
Adding a Tape Drive to the Tape
Enclosure 6-2
Note. This section explains in detail how the user will be able to easily add a tape drive or
remove it from the tape enclosure
.