HP StorageWorks Enterprise File Services WAN Accelerator - Manual (Page 127)

HP S TORAGE W ORKS EFS WAN A CCELERATOR M ANAGEMENT C ONSOLE U SER G UIDE 127
2 C
ONF
IGUR
ING
TH
E
HP
EF
S
WA
N
A
CC
EL
ERA
T
O
R
4. Use the controls to complete the configuration, as described in the following table.
5. Click Save to save your settings permanently or click Reset to return the settings
to their previous values.
Setting Authentication Methods
This section describes how to set administrator and monitor passwords, Remote
Authentication Dial-In User Service (RADIUS), and Terminal Access Controller
Access Control System (TACACS+) authentication. It includes the following sections:
‹ “Setting General Authentication,” next
‹ “Setting the Administrative Password” on page 129
‹ “Setting the Monitor Password” on page 130
‹ “Setting RADIUS Servers” on page 131
‹ “Setting TACACS+ Servers” on page 133
‹ “Modifying Web Settings” on page 135
‹ “Setting the Message of the Day (MOTD)” on page 136
Setting General
Authentication You can prioritize local, RADIUS, and TACACS+ authentication methods for the
system and set the authorization policy and default user for RADIUS and TACACS+
authorization systems in the Setup: Authentication - General Settings page.
IMPORTANT: Make sure to put the authentication methods in the order in which you want
authentication to occur. If authorization fails on the first method, the next method is attempted,
and so forth, until all the methods have been attempted.
TIP: To set TACACS+ authorization levels (admin or read-only) to allow certain members of
a group to log in, add the following attribute to users on the TACACS+ server:
service = rbt-exec {
local-user-name = "monitor"
Control Description
Add New NTP Server Server IP. Specify the IP address for the NTP server.
Version. Select the NTP protocol version number from the drop-down list.
Enabled. Select True to enable synchronization; select False to disable.
Add Server. Click Add Server to add the NTP server to the list.
Enable/Disable. Enable or disable an NTP server.
Remove Selected Servers. To remove an entry, click the check box next to the entry and
click Remove Selected Servers.