HP StorageWorks XP Remote Web Console Software - Manual (Page 73)

Setting SNMP Agent Properties 73
4-3-3 Adding A Community Name
To add a community name:
1. Change to Modify mode.
2. Click Install ( ).
3. Click the SNMP IP Security tab.
4. In the Community &Trap box, select and right-click on Community. The Add Community pop-up menu is
displayed (see Figure 4-5).
5. Click the Add Community command. The Community pane (see Figure 4-6) is displayed.
6. In the Community text box, enter the desired community name (up to 180 alphanumeric characters,
excluding ” * $ ^ | < > ? % & \ and space).
7. Click OK. The new community name is displayed in Community & Trap, but the changes are not yet
implemented in the subsystem.
8. If you want to add one or more IP addresses to the new community, see section 4-3-6.
9. If you want to apply the changes to the subsystem, click Apply. Click OK (or Cancel).
Figure 4-5 Add Community Pop-Up Menu
Figure 4-6 Add Community Pane