Powering on the extended library, Sliding the pull-out tab into the library, Tightening the extender thumbscrews – HP StoreEver MSL Tape Libraries User Manual
Page 40
2.
When the Extender reaches the pull-out tab, thread the pull-out tab through the slit in the Extender
attachment plate so the plastic extension of the pull-out tab is outside of the Extender. This will
allow the Extender to seat completely and allow the information on the tab to be viewed after
the Extender is installed. Slide the Extender the rest of the way into the Libraries and then slide
the pull-out tab into the Library as shown in
Figure 26 Sliding the pull-out tab into the Library
.
3.
Tighten the two thumbscrews on each side of the Extender with your fingers or a #1 Phillips
screwdriver to secure the Extender to the Libraries as shown in
Figure 27 Tightening the Extender thumbscrews
.
4.
From the front of the Libraries, tighten the captive screws inside the right and left front bezels that
were loosened earlier in the procedure.
5.
Connect an Ethernet cable to a working LAN connection and to the Ethernet connector on the
back of the master Library.
6.
Attach a power cable to each power connector on the back panels of the Libraries. Plug the
power cables into the nearest properly grounded power outlet.
Powering on the extended library
Power on both Libraries with the power buttons on the front panel as shown in
The Libraries can be powered on in either order. The initialization sequence is faster when the lower
Library is powered on first.
Installing the Library Extender
40