HP Color LaserJet Enterprise CP4525 Printer series - Manual (Page 184)

4. Unscrew the thumb screws and then pull the formatter board from the product. Place the formatter
board on a clean, flat, grounded surface.
5. To replace a DIMM that is currently installed, spread the latches apart on each side of the DIMM
slot, lift the DIMM up at an angle, and pull it out.
XO XO XO
XO XO XO
XOXOXOXOXOXO
XO XO XOXO XO
XOX OX OXO XO
XO XOX OXO XO
XOXO XO XO XO
XOXOXOXOXOXO
XOXO XO XO XO
XOXOXO XOXOXO
XOXOXO
XOXOXO
XOXOXO
XOXOXO
XOXOXO
XOXOXO XOXOXO
XO XO XO
X O X O XO
XOXOXOXO XO XO XO
XO XO XO
XOXOXO
6. Remove the new DIMM from the antistatic package. Locate the alignment notch on the bottom
edge of the DIMM.
170 Chapter 9 Manage and maintain ENWW