HP Color LaserJet Enterprise CP4525 Printer series - Manual (Page 213)

Description Recommended action
REPLACE SUPPLY
Printing black only
At least one print cartridge has reached the
very low condition and you have set the
COLOR CARTRIDGES items to the PRINT
IN BLACK option.
The supply life remaining is used to
determine if a supply is very low. The supply
life remaining is an approximation only and
varies depending on the types of documents
printed and other factors.
No action is required for printing to continue
in black. To continue printing in color, either
replace the print cartridge or reconfigure the
product by using the MANAGE SUPPLIES
menu on the control panel.
For more information about ordering
supplies, see
Supplies and accessories
on page 235 .
For more information about the MANAGE
SUPPLIES menu, see
Manage supplies
menu on page 16 .
REPLACE TONER COLLECTION UNIT The product indicates when a toner collection
unit is at its estimated end of life. The actual
life remaining might be different than the
estimation. Have a replacement toner
collection unit available to install when print
quality is no longer acceptable. The toner
collection unit does not need to be replaced
now unless the print quality is no longer
acceptable. After a toner collection unit has
reached its approximated end of life, HP’s
premium Protection Warranty on that toner
collection unit ends. Replace the toner collection unit.
If you wish to have the toner collection unit
operate past its estimated capacity, configure
the product to continue printing by using the
MANAGE SUPPLIES menu. For more
information about the MANAGE SUPPLIES
menu, see
Manage supplies menu
on page 16 . This is not a recommended
option because of the risk of overfilling the
toner collection unit, which could result in the
need to service the product.
REPLACE TRANSFER KIT The product indicates when a transfer kit is at
its estimated end of life. The actual life
remaining might be different than the
estimation. Have a replacement transfer kit
available to install when print quality is no
longer acceptable. The transfer kit does not
need to be replaced now unless the print
quality is no longer acceptable. After a
transfer kit has reached its approximated end
of life, HP’s premium Protection Warranty on
that transfer kit ends. Replace the transfer kit. Instructions are
included with the transfer kit.
Request accepted please wait The product has accepted a request to print
an internal page, but the current job must
finish printing before the internal page will
print. No action is necessary.
Resend Upgrade The firmware upgrade was not completed
successfully. Attempt upgrade again.
Resetting kit count You have selected the option to reset the
count for a new supply item. No action is necessary.
Restoring factory settings The product is restoring factory settings. No action is necessary.
Restoring... The product is restoring settings. Please wait until the process is complete.
RESTRICTED FROM PRINTING IN COLOR This message appears when color printing is
disabled for the product or when it is disabled
for a particular user or print job.
To enable color printing for the product,
change the RESTRICT COLOR USE setting
in the
Manage supplies menu on page 16 .
ROM DISK DEVICE FAILURE
To clear press OK
The specified device has failed. Press the OK button to clear.
Table 10-1 Control-panel messages (continued)
ENWW Interpret control-panel messages 199