HP Color LaserJet Enterprise CP4525 Printer series - Manual (Page 211)

Description Recommended action
Processing... The product is currently processing a job but
is not yet picking pages. When paper motion
begins, this message will be replaced by a
message that indicates which tray the job is
being printed from. No action is necessary.
Processing...
CLEANING PAGE
The product is processing a cleaning page. No action is necessary.
Processing... copy <X> of <Y> The product is currently processing or
printing collated copies. The message
indicates that copy X of Y total copies is
currently being processed. No action is necessary.
Processing... from tray <X> The product is actively processing a job from
the designated tray. No action is necessary.
RAM DISK DEVICE FAILURE
To clear press OK
The specified device has failed. Press the OK button to clear.
RAM DISK FILE OPERATION FAILED
To clear press OK
A PJL file system command attempted to
perform an illogical operation. Press the OK button to clear.
RAM DISK FILE SYSTEM IS FULL
To clear press OK
A PJL file system command could not store
something on the file system because the file
system was full. Press the OK button to clear.
RAM DISK IS WRITE PROTECTED
To clear press OK
The file system device is protected and no
new files can be written to it. Press the OK button to clear.
RAM DISK NOT INITIALIZED This file-storage component must be
initialized before use. Use the HP Embedded Web Server or
HP Web Jetadmin to initialize the component.
Ready The product is online and ready for data. No
status or product attendance messages are
pending at the display. No action is necessary.
Ready
IP ADDRESS
The product is online and ready. No action is necessary.
Ready Diagnostics mode
To exit press
The product is in Diagnostics mode. To stop Diagnostic mode, press the Stop
button
.
Receiving Upgrade A firmware upgrade is in progress. Do not turn the product off until the product
returns to Ready.
Remove all print cartridges
To exit press
The product is testing the transfer unit
assembly. To perform the test, remove all the print
cartridges. To cancel the test, press the stop
button
.
Remove at least one print cartridge
To exit press
The product is testing the print-cartridge
motor. To perform the test, remove at least one print
cartridge. To cancel the test, press the stop
button
.
REMOVE CARTRIDGE LOCKS At least one cartridge shipping lock was not
removed before you turned the product on. 1. Open the front door.
2. Remove cartridge locks.
Table 10-1 Control-panel messages (continued)
ENWW Interpret control-panel messages 197