HP Color LaserJet Enterprise CP4525 Printer series - Manual (Page 214)

Description Recommended action
ROM DISK FILE OPERATION FAILED
To clear press OK
A PJL file system command attempted to
perform an illogical operation. Press the OK button to clear.
ROM DISK FILE SYSTEM IS FULL
To clear press OK
A PJL file system command could not store
something on the file system because the file
system was full. Press the OK button to clear.
ROM DISK IS WRITE PROTECTED
To clear press OK
The file system device is protected and no
new files can be written to it. Press the OK button to clear.
Rotating <color> Motor
To exit press
A component test is in progress; the
component selected is the <color> cartridge
motor. Press the stop button when ready to stop
this test.
Rotating Motor
To exit press
The product is executing a component test
and the component selected is a motor. Press the stop button when ready to stop
this test.
SANITIZING DISK <X>% COMPLETE
Do not power off
The hard disk is being cleaned. Contact the network administrator.
SIZE MISMATCH IN TRAY XX The paper in the listed tray does not match
the size specified for that tray. 1. Load the correct paper.
2. Verify the paper is positioned correctly.
3. Close the tray and verify that the control
panel lists the correct paper size and
type. Reconfigure the size and type if
necessary.
4. If the message persists, contact HP
support. See
Customer support
on page 246 .
Sleep mode on The product is in sleep mode. A button press,
receipt of printable data, or an error condition
will clear this message. No action is necessary.
STANDARD TOP BIN FULL
Remove all paper from bin
The output bin is full. Empty the bin and continue printing.
SUPPLIES IN WRONG POSITION Two or more print-cartridge slots contain the
wrong color print cartridge.
From left to right, the print cartridges should
be installed in this order:
● Yellow
● Magenta
● Cyan
● Black
Install the correct color cartridge in each slot.
Table 10-1 Control-panel messages (continued)
200 Chapter 10 Solve problems ENWW