HP Color LaserJet Enterprise CP4525 Printer series - Manual (Page 51)

Item Sub-item Sub-item Sub-item Description
SNMP TEST YES
NO*
This test checks operation of SNMP
communications by accessing predefined
SNMP objects on the product.
Select YES to choose this test, or NO to not
choose it.
DATA PATH TEST YES
NO*
This test helps to identify data path and
corruption problems on an HP postscript level
3 emulation product. It sends a predefined PS
file to the product, However, the test is
paperless; the file will not print.
Select YES to choose this test, or NO to not
choose it.
SELECT ALL
TESTS YES
NO*
Use this item to select all available embedded
tests.
Select YES to choose all tests. Select NO to
select individual tests.
EXECUTION TIME
[H] Use this item to specify the length of time (in
hours) that an embedded test will be run. You
can select a value from 0 to 24 hours. If you
select zero (0), the test runs indefinitely until
an error occurs or the product is turned off.
Data gathered from the HTTP, SNMP, and
Data Path tests is printed after the tests have
completed.
EXECUTE YES
NO*
NO: Do not initiate the selected tests.
YES: Initiate the selected tests.
PING TEST This test is used to check network
communications. This test sends link-level
packets to a remote network host, then waits
for an appropriate response. To run a ping
test, set the following items:
DEST TYPE IPV4
IPV6
Specify whether the target product is an IPv4
or IPv6 node.
DEST IPV4 Type the IPv4 address.
DEST IPV6 Type the IPv6 address.
PACKET SIZE Specify the size of each packet, in bytes, to
be sent to the remote host. The minimum is
64 (default) and the maximum is 2048.
TIMEOUT Specify the length of time, in seconds, to wait
for a response from the remote host. The
default is 1 and the maximum is 100.
COUNT Specify the number of ping test packets to
send for this test. Select a value from 0 to 100.
The default is 4. To configure the test to run
continuously, select 0.
Table 2-1 Embedded Jetdirect menu (continued)
ENWW Control panel menus 37