HP Color LaserJet Enterprise CP4525 Printer series - Manual (Page 217)

Description Recommended action
TRAY <X> [TYPE] [SIZE]
To change size or type press OK
To accept settings press
This message states the current type and
size configuration of the tray. To change size or type press the OK button.
To accept settings press the back arrow .
TRAY <X> EMPTY [TYPE] [SIZE] The specified tray is empty and the current
job does not need this tray to print. Refill the tray at a convenient time.
TRAY <X> OPEN The specified tray is open or not closed
completely. Close the tray.
TRAY <X> OVERFILLED
Remove some paper
The tray is filled above the stack-height
marking. Remove enough paper so that the paper
stack does not exceed the limit for the tray.
TRAY <X> SIZE = <Size>
Media insert required in tray
The product is set to print on a small paper
size that requires the HP postcard media-
insert to be installed in this tray. To use this size paper, install the media insert
before loading the paper. See
Load paper
trays on page 90 .
If you do not have the HP postcard media
insert, 100 x 150 mm (4 x 6 in) paper can be
printed from Tray 1 without the insert.
TYPE MISMATCH IN TRAY X The specified tray contains a paper type that
does not match the configured type. The specified tray will not be used until this
condition is addressed. Printing can continue
from other trays.
1. Load the correct paper in the specified
tray.
2. Verify the type configuration.
UNABLE TO COPY JOB The product does not have enough memory
to produce multiple original prints of this job.
One copy will be printed. Add more memory to the product. See Install
memory DIMMs on page 169 .
UNABLE TO STORE JOB A job cannot be stored because of a memory
or configuration problem. Install additional memory in the product.
Unsupported data on [FS] DIMM in slot x
To clear press OK
The data on the DIMM for the indicated file
system is not a type that the product supports.
[FS] can be either a ROM or Flash file system. Press the OK button to clear the message.
Replace the DIMM. See Install memory
DIMMs on page 169 .
UNSUPPORTED DRIVE INSTALLED A non-supported hard drive has been
installed. Turn off the product, remove the hard drive,
and then turn on the product.
UNSUPPORTED SUPPLY INSTALLED
To continue press OK
The print cartridge is for a different HP
product. If print quality is no longer acceptable, replace
the print cartridge.
For a list of supported print cartridges, see
Supplies and accessories on page 235 .
USB ACCESSORIES EXCEED POWER
LIMIT A USB accessory is drawing too much
electrical current. Printing cannot continue. Remove the USB accessory, and then restart
the product.
Use a USB accessory that uses less power
or that contains its own power supply.
USB ACCESSORY ERROR This message appears when a connected
USB accessory draws too much power.
When this happens, the ACC port is disabled
and printing stops. Remove the USB accessory, and then restart
the product
Use a USB accessory that uses less power
or that contains its own power supply.
Table 10-1 Control-panel messages (continued)
ENWW Interpret control-panel messages 203