HP 3PAR Application Software Suite for Oracle - Manual (Page 29)

2. Use the pkgrm command as follows:
# pkgrm <package_name>
For versions prior to, or equal to, 3.0.4, the package name is VCDBAora. Starting with version
4.1.0, the package name is RMOra.
Installing Recovery Manager for Oracle on HP UX Systems
Use the instructions in this section to install Recovery Manager for Oracle on the database and
backup servers.
If you are not using the backup server as the NetBackup master server, be sure to install Recovery
Manager for Oracle on the NetBackup master server.
Starting Installation
The following section describes the steps necessary for installing Recovery Manager for Oracle on
an HP UX system:
CAUTION: When upgrading to a newer version of Recovery Manager, any previously installed
versions of Recovery Manager must be removed. Use the swremove RMOra command to remove
the previously installed package.
1. Log in as the root user.
2. Insert the 3PAR Recovery Manager CD into a CD-ROM drive.
NOTE: If the CD is not mounted automatically, you can mount it manually.
# mount -t iso9660 -r /dev/cdrom /mnt/cdrom
3. Change to the CD-ROM drive.
# cd /mnt/cdrom0/HP-UX
4. Issue the swinstall command as follows:
# swinstall -s `pwd` RMOra
Verifying Installation
1. Log in as the root user.
2. Enter the swlist command and verify:
•
Name displays the correct package name, in this case RMOra.
•
Version displays the current version, in this case 4.2.0.
3. After the installation is complete on all the required servers, you can allow Oracle users and
the Database Administrators group access to the Recovery Manager commands and utilities
by changing the owner and permissions of the following directories (required for Oracle users):
•
/opt/3PAR/RMOra
•
/etc/3par/solutions/tasks
•
/etc/3par/solutions
Installing Recovery Manager for Oracle on HP UX Systems 29