HP 3PAR Application Software Suite for Oracle - Manual (Page 27)

If you are not using the backup server as the NetBackup master server, be sure to install Recovery
Manager for Oracle on the NetBackup master server.
CAUTION: Before you upgrade to a new version of 3PAR Recovery Manager, deinstall any
previously installed versions of Recovery Manager. To remove a previously installed package, log
on as the root user and use the pkgrm <package_name> command. For versions prior to, or
equal to, 3.0.4, the package name is VCDBAora. Starting with version 4.1.0, the package name
is RMOra.
Starting Installation
To install 3PAR Recovery Manager on a Solaris system:
Procedure 1
1. Log on as the root user.
2. Insert the 3PAR Recovery Manager CD into a CD-ROM drive.
If the CD is not mounted automatically, you will need to mount it manually.
# mount -F hsfs -o ro /dev/dsk/c0t6d0s2/cdrom
3. Change to the CD-ROM drive.
# cd /cdrom/cdrom0/Solaris
4. Use the pkgadd command as follows:
# pkgadd -d . RMOra
You will be prompted to answer several questions about creating the installation area and the
setuid
files to be installed.
NOTE: Install the following patch if applicable:
•
Solaris 5.10 requires patch 119130-26, or higher.
The following command can be used to verify whether the patches are installed or not:
•
showrev -p | grep 119130
Verifying Installation
To verify 3PAR Recovery Manager installation on a Solaris system:
1.
Log in as the root user.
2. Use the pkginfo command as follows:
# pkginfo -l RMOra
PKGINST: RMOra
NAME: HP 3PAR Recovery Manager Software for Oracle on Solaris
CATEGORY: application
ARCH: Sparc
VERSION: 4.2.0.10
BASEDIR: /opt/3PAR/RMOra
VENDOR: Hewlett-Packard Development Company
DESC: HP 3PAR Recovery Manager Software for Oracle on Solaris
PSTAMP: RMOra-4.2.0:03-26-2012_19:09:48
Installing Recovery Manager on Solaris Systems 27