HP LaserJet 5100 Printer series - Manual (Page 141)

ENWW
Control Panel Menus B-5
MANUAL FEED=OFF OFF
ON Feed the paper manually from Tray 1, rather
than automatically from a tray. When
MANUAL FEED=ON and Tray 1 is empty, the
printer goes offline when it receives a print job
and displays
MANUALLY FEED [PAPER
SIZE] .
For more information, see page 56.
DUPLEX=OFF OFF
ON This item appears only when an optional
duplexer is installed. Set the value to
ON to print
on both sides (duplex) or OFF to print on one
side (simplex) of a sheet of paper.
For more information, see page 33.
BINDING=
LONG EDGE LONG EDGE
SHORT EDGE This item appears only when an optional
duplexer is installed and the duplex option is
on. Choose the binding edge when duplexing
(printing on both sides of paper).
For more information, see page 33.
OVERRIDE A4/
LETTER=NO NO
YES Choose YES to print on letter size paper when
an A4 job is sent, but no A4 size paper is loaded
in the printer (or to print on A4 size paper when
a letter job is sent, but no letter paper is loaded
in the printer).
CONFIGURE FUSER
MODE MENU=NO NO
YES Configure the fuser mode associated with each
paper type. (This is only necessary if you are
experiencing problems printing on certain
paper types.)
NO : The fuser mode menu items are not
accessible.
YES : Additional items appear (see below).
Note
To see the default fuser mode for each paper
type, select
YES , scroll back to the Information
Menu, and print a menu map (page B-3).
[TYPE]=
NORMAL NORMAL
LOW
HIGH
VELLUM This item appears only when CONFIGURE
FUSER MODE MENU=YES . Most paper types
are set to NORMAL by default.
The exceptions are as follows:
ROUGH=HIGH
VELLUM=VELLUM
For a complete list of supported paper types,
see page A-7.
Paper Handling Menu (Continued)
Item Values Explanation