HP LaserJet 5100 Printer series - Manual (Page 155)

ENWW
Control Panel Menus B-19
CFG TCP/IP=NO NO
YES NO : The TCP/IP Menu is not accessible.
YES : The TCP/IP Menu appears. In the TCP/
IP Menu, you can specify BOOTP=YES or
DHCP=YES for TCP/IP parameters to be
automatically loaded from a bootp or DHCP
server when the printer is turned on. If you
specify
BOOTP=NO and DHCP=NO , you can
manually set selected TCP/IP parameters from
the control panel. You can manually set each
byte of the IP address (IP), Subnet Mask (SM),
Syslog Server (LG), and Default Gateway
(GW). For example:
If the Syslog Server IP address is left blank, the
printer will still work. Also, you can manually set
the Timeout time period.
CFG LINK=NO NO
YES NO: The 10/100Base-TX link configuration
menu will not be accessed.
YES: Allows you to access and manually set
10/100Base-TX link parameters.
• AUTO: (Default) The print server will
automatically configure itself to match the
network’s link speed and communication
mode.
• 10T HALF: Sets 10 Mbps, Half-duplex
operation on the print server.
• 10T FULL: Sets 10 Mbps, Full-duplex
operation on the print server.
• 100TX HALF: Sets 100 Mbps, Half-duplex
operation on the print server.
• 100TX FULL: Sets 100 Mbps, Full-duplex
operation on the print server.
EIO Menu (Continued)
Item Values Explanation
192.0.0.192
Byte 1
Byte 2 Byte 3
Byte 4