HP LaserJet 5100 Printer series - Manual (Page 38)

30 Chapter 2: Printing Tasks
ENWW
5 Align the rear guide with the desired
paper size. With the guide angled
slightly toward the front of the tray,
insert the two front tabs (A) into the
appropriate holes. Push the guide
upright, snapping the center tab (B)
into place.
The guide must always be placed
correctly in the tray (even for 11 x 17
or A3 paper).
6 Adjust the side guides to the proper
size.
7 Load the tray. For correct
orientation, see page 39.
8 Make sure the paper is flat in the tray
at all four corners and below the tabs
on the guides.
9 Close the tray cover. Slide the tray
back into the printer.
Note
If you want to print by type and size of
paper from the printer driver, configure
the tray settings in the printer’s control
panel to match the type of paper loaded
in each tray (page 57).
B
A
A