HP LaserJet 5100 Printer series - Manual (Page 92)

84 Chapter 4: Problem Solving
ENWW
CHOSEN LANGUAGE
NOT AVAILABLE A print job requested a printer language that does not exist in the
printer. The job will not print and will be cleared from memory.
Print the job using a driver for a different printer language, or add the
requested language to the printer (if available).
Press [Go] to continue.
CLOSE TOP COVER The top cover is open and must be closed for printing to continue.
DISK DEVICE
FAILURE The EIO disk had a critical failure and can no longer be used.
Remove the EIO disk and replace it with a new one.
DISK FILE
OPERATION FAILED The requested operation could not be performed. You might have
attempted an illegal operation, such as trying to download a file to a
non-existent directory.
DISK FILE
SYSTEM IS FULL Delete files from the EIO disk and then try again, or add a flash DIMM.
Download or delete files from HP Web JetAdmin, and download or
delete fonts. (See the printer software help for more information.)
DISK IS
WRITE PROTECTED The EIO disk is protected, and no new files can be written to it.
Disable the write protection through HP Web JetAdmin.
EIO n
NOT FUNCTIONAL The EIO network card is not working correctly.
Reseat the EIO accessory. If the message continues, replace it with
a new EIO accessory.
EIO n DISK
INITIALIZING The disk accessory card takes a long time to initialize. The first
parameter is the accessory slot number for this disk accessory card.
EIO n DISK
NOT FUNCTIONAL The EIO disk is not working correctly.
Remove the EIO disk from the slot indicated.
Reseat the EIO disk. If the message continues, replace it with a new
EIO disk.
EIO n
INITIALIZING
alternates with
DO NOT POWER OFF
Wait for the message to disappear (approximately 5 minutes). If the
printer EIO card is operating correctly and communicating with the
network, this message disappears after approximately one minute
and no action is required.
If the EIO card is unable to communicate with the network, this
message remains for five minutes and then disappears. In this case
the printer is not communicating with the network (even though the
message is no longer present). The problem may be a bad EIO card,
a bad cable or connection on the network, or a network problem.
Contact your network administrator.
EIO n DISK
SPINNING UP The disk accessory card takes a long time to initialize. The first
parameter is the accessory slot number for this accessory card.
Printer Messages (Continued)
Message Explanation or Recommended Action