HP MPX200 Multifunction Router - Manual (Page 111)

MPX200 iSCSI/FCIP configurations
The MPX200 router supports the following configurations:
•
Figure 93 (page 111) MPX200 basic FCIP configuration with one or two long-distance links
•
Figure 94 (page 112) MPX200 FCIP with B-series Integrated Routing
•
Figure 95 (page 112) MPX200 FCIP with C-series IVR
•
Figure 96 (page 112) MPX200 high-availability configuration with one or two long-distance
links
•
Figure 97 (page 113) MPX200 high-availability configuration with fully-redundant long-distance
links
•
Figure 98 (page 113) MPX200 configuration with remote IP distance gateway (mpx110)
•
Figure 99 (page 113) MPX200 highly-redundant configuration with one or two long-distance
links
•
Figure 100 (page 114) MPX200 highly redundant pairs of gateways with fully-redundant
long-distance links
•
Figure 101 (page 114) MPX200 simultaneous iSCSI and FCIP with remote dedicated FCIP
blade
•
Figure 102 (page 115) MPX200 simultaneous iSCSI and FCIP, both local and remote
•
Figure 103 (page 115) MPX200 iSCSI and FCIP dedicated blades, both local and remote
•
Figure 104 (page 116) HP Continuous Access 3-site configuration with four MPX200 routers
•
Figure 105 (page 117) HP Continuous Access 3-site configuration with six MPX200 routers
•
Figure 106 (page 118) HP Continuous Access 3-site configuration with eight MPX200 routers
•
Figure 107 (page 119) HP Continuous Access 3-site configuration with six MPX200 router full
peer-to-peer connectivity
Figure 93 MPX200 basic FCIP configuration with one or two long-distance links
Figure 94 (page 112) shows a configuration using MPX200 with FCIP and B-series switches with
Integrated Routing. This provides fabric isolation between the local and remote fabrics, allowing
device access without merging the fabrics. This can be implemented in all supported MPX200 FCIP
configurations using B-series Fibre Channel switches with Integrated Routing or B-series routers
configured for Fibre Channel routing.
MPX200 iSCSI/FCIP configurations 111