HP MPX200 Multifunction Router - Manual (Page 41)

Figure 33 The set mgmt command.
Setting up the iSCSI ports
The iSCSI ports require an IP address. Enter the set iscsi command to set the IP addresses.
See
Figure 34 (page 41) .
Figure 34 The set iscsi command
Fibre Channel zoning
Use the following diagram as a guide to implement zones. Use the show vpgroups command
to determine the MPX200 WWNs used in zoning (see
Figure 35 (page 42) ). Zones include WWNs
from the MPX200 and the 3PAR array ports.
Setting up the iSCSI ports 41