HP MPX200 Multifunction Router User Manual
Page 43
Advertising
1.
Run the show vpgroups command and observe the fourth bit in the output to identify the
WWNs belonging to a VPG. See
Figure 36 The show vpgroups command
2.
Using the InForm Management Console, create a host and add only WWNs that belong to
the same VPG.
There can be up to four hosts that represent the MPX200.
NOTE:
shows an example with eight connections from the MPX200 to
the array. Each of the four FC ports detects two array ports.
Figure 37 Host properties
LUN provisioning
43
Advertising