HP MPX200 Multifunction Router - Manual (Page 147)

Figure 127 iSCSI controller properties
Issues and solutions
HP P6000 Command View does not discover MPX200
Solution 1: Ensure that a DHCP server is available.
Solution 2: Use the CLI to set a static IP address on each MPX200 blade.
Solution 3: Ensure that the HP P6000 Command View station is on the same subnet as the
management ports.
Solution 4: Enter the known IP address of the management port of the iSCSI controller in the HP
P6000 Command View discovery screen.
Initiator cannot log in to MPX200 iSCSI target
Solution 1: Ensure that you are using the correct iSCSI port IP address.
Solution 2: In HP P6000 Command View, for each controller, click the IP ports tab, and verify the
IP Address settings (
Figure 128 (page 148) ).
Issues and solutions 147