6 managing mpx200 iscsi for xp24000/20000, Setting up the mpx200 management port – HP MPX200 Multifunction Router User Manual
Page 46
6 Managing MPX200 iSCSI for XP24000/20000
This chapter describes management procedures for configuring and managing MPX200 iSCSI
with XP24000/20000 storage systems. For more information, see
rules and guidelines” (page 52)
Setting up the MPX200 management port
Access to the MPX200 CLI is required for initial setup. Connect to the CLI through one of the
following:
•
RS-232 serial port (115200/8/n/1)
•
Telnet
•
SSH
By default, the management port obtains a DHCP address. If the management port cannot obtain
a DHCP address, you must set a static IP address. HP highly recommends using static IP addresses
to retain connectivity.
When connected, select the blade to manage by using the blade <1 | 2> command (see
).
Figure 41 The blade # command
Use the admin start command to change settings (see
).
Figure 42 The admin start command
Use the set mgmt command to setup the management port IP address (see
).
46
Managing MPX200 iSCSI for XP24000/20000