HP MPX200 Multifunction Router - Manual (Page 91)

Installing the QLogic iSCSI HBA
Install the QLogic iSCSI HBA hardware and software following the instructions in the QLogic
installation manual. The QLogic iSCSI HBA is managed by the QLogic SANsurfer Management
Suite (SMS).
NOTE: After installing the QLogic iSCSI HBA, you must configure the QLogic iSCSI initiator
through SMS. The QLogic iSCSI HBA does not appear in the Microsoft Network Connection device
list.
Installing the Microsoft iSCSI initiator services and MPIO
To install the Microsoft iSCSI initiator:
1.
Access the Microsoft iSCSI Initiator Installation page of the Software Update Installation Wizard
(
Figure 81 (page 91) ).
Figure 81 Microsoft iSCSI Initiator Installation page
IMPORTANT: Do not select the Software Initiator check box. The QLogic initiator resides on
the iSCSI HBA.
2. Reboot the system.
Configuring the QLogic iSCSI HBA
To configure the QLogic iSCSI HBA:
1.
Launch the QLogic SMS from the desktop icon or through Start > Programs, and connect to
the local host (
Figure 82 (page 92) ).
Setting up the iSCSI initiator 91