HP MPX200 Multifunction Router - Manual (Page 193)

Admin session Authority
setup
start wanlinktest Syntax
show
stop
Configures the WAN link test parameters on the server side
of the WAN link. setup Keywords
Begins running the WAN link test on the client side of the
WAN link. start
Displays the outcome of the WAN link test on the client or
the status and port number of the server if running. show
Terminates running the WAN link test. stop
NOTE: When setting up or starting the test, ensure that the Gige Port parameter specifies the
same port number as the WAN link test server and the client.
Example 1:
The following example illustrates the use of the wanlinktest setup command.
MPX200 <2>(admin) #> wanlinktest setup
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
Gige Port (0=Mgmt, 1=GE1, 2=GE2, ...) [Mgmt ] 1
Is Local IP already configured (y=yes, n=no) [y ] N
Local IP Address (IPv4 or IPv6) [0.0.0.0 ] 1.1.1.1
Subnet Mask [0.0.0.0 ] 255.255.255.0
Gateway [0.0.0.0 ]
MTU (Min=582, Max=9000) [1500 ]
VLAN (0=Enable, 1=Disable) [1=Disable]
Server Port to listen On (3225 FCIP/3260 iSCSI)[ ] 3260
Started iperf Server on port 1 (socket 3260) sucessfully..!
Example 2:
The following example illustrates the use of the wanlinktest start command.
MPX200 <1>(admin) #> wanlinktest start
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
Gige Port (0=Mgmt, 1=GE1, 2=GE2, ...) [Mgmt ] 1
Is Local IP already configured (y=yes, n=no) [y ] N
Local IP Address (IPv4 or IPv6) [0.0.0.0 ] 1.1.1.2
Subnet Mask [0.0.0.0 ] 255.255.255.0
Gateway [0.0.0.0 ]
MTU (Min=582, Max=9000) [1500 ]
VLAN (0=Enable, 1=Disable) [1=Disable]
Test Duration in Minutes (multiples of 5) [10 ]
Server Port to connect to 3225 FCIP/3260 iSCSI)[ ] 3260
Checking whether resources are available to start WAN LINK TEST
Commands 193