HP StorageWorks 2.140 Director Switch - Manual (Page 153)

HA-Fabric Manager user guide 151
The Add Zone Member dialog box is displayed ( Figure 92 ).
Figure 92 Add Zone Member dialog box
5. Specify a zone member by its domain and port ID or WWN address.
NOTE: Zoning by domain and port is supported only in Homogeneous Fabric interop mode.
Do one of the following:
• Select Domain/Port and enter the domain and port IDs in the appropriate boxes.
• Select WWN and enter the WWN address.
NOTE: If you select an invalid domain/port value or WWN address and then activate the zone
set, the application shows a zoning mismatch message after the next discovery pass.
6. Click OK.
The Zoning dialog box is displayed (
Figure 91 on page 149).
7. Select an option from the Zoning Method list.
8. Select the members to add to the zone from the Potential Zone Members list. To add all ports on
a device, select the device.
9. Click to the right of the Potential Zone Members list to add the selected members to the zone.
10. Click OK.
NOTE: If you click Cancel or the close button (X), without clicking OK, only the changes that you
made to the active zone set are saved.
Creating a zone set
To create a new zone set:
1. Display the zone library. See ” Displaying the zone library ” on page 149.
The Zoning dialog box is displayed ( Figure 91 on page 149).
2. Click New Set to create a new zone set.
3. Rename the zone set. See ” Zoning naming conventions ” on page 148.
4. Press Enter.