HP StorageWorks 2.140 Director Switch User Manual

Page 236

Advertising
background image

Informational and error messages

240

Cannot start port

diagnostics.

Port diagnostics cannot

be started at the Element

Manager because the

Ethernet link is down or

busy.

Retry the operation later. If the

condition persists, contact the next

level of support.

Cannot swap an

uninstalled port.

A port swap cannot be

performed when the port

card is not installed.

Perform a swap only on a port that

is installed.

Click OK to remove all

contents from log.

This action deletes all

contents from the selected

log.

Click OK to delete the log contents

or click Cancel to cancel the

operation.

Connection to

management server lost.

Click OK to exit

application.

The HAFM application at

a remote workstation lost

the network connection to

the HAFM appliance.

Start the HAFM application to

connect to the HAFM appliance.

Continuing may overwrite

host programming.

Continue?

Configurations sent from

the host can be

overwritten by HAFM.

Continuing will activate the current

configuration, which may have

been configured by a FICON host.

Could not export log to

file.

A log file I/O error

occurred and the file

could not be saved to the

specified destination. The

disk can be full or write

protected.

Ensure file name and drive are

correct.

Could not find firmware

file.

Firmware file selected

was not found in the FTP

directory. Or, the selected

file is not a firmware file.

Ensure file name and directory are

correct. Or, obtain a valid firmware

file from your service

representative.

Could not remove dump

files from server.

Dump files could not be

deleted from the HAFM

appliance because the

link can be down, or the

HAFM appliance or

Element Manager is busy.

Retry the operation later. If the

condition persists, contact the next

level of support.

Could not stop port

diagnostics.

Port diagnostics could not

be stopped by the

Element Manager

because the Ethernet link

is down or busy, or

because the director is

busy.

Retry the operation later. If the

condition persists, contact the next

level of support.

Table 31

Element Manager messages (continued)

Message

Description

Action

Advertising