HP StorageWorks 2.140 Director Switch - Manual (Page 244)

Informational and error messages 248
Invalid value for second
(0-59).
At the Configure Date
and Time dialog box, the
SS value (second) must be
an integer from 0 through
59 inclusive.
Verify and enter a valid time.
Invalid value for threshold
(1-99)%.
Value entered for each
port in the Configure
Open Trunking dialog
box must be in the range
from 1 to 99. This
message is displayed if
the optional Open
Trunking feature is
installed.
Enter a number from 1 to 99 into
the Threshold % column of the
Configure Open Trunking dialog
box.
Invalid value for year. At the Configure Date
and Time dialog box, the
YYYY value (year) must
be a four-digit value.
Verify and enter a four-digit value
for the year.
Invalid World Wide
Name or nickname.
The WWN or nickname
that you have specified is
invalid. The valid format
for the WWN is eight
two-digit hexadecimal
numbers separated by
colons (xx:xx:xx:xx:xx:
xx:xx:xx). The valid
format for a nickname is
non blank characters, up
to 32 characters.
Try the operation again using a
valid WWN or nickname.
Link dropped. The HAFM
appliance-to-director
Ethernet link was
dropped.
Retry the operation. Link reconnects
are attempted every 30 seconds. If
the condition persists, contact the
next level of support.
Log is currently in use. Access to the log is
denied because the log
was opened by another
instance of the Element
Manager.
Retry the operation later. If the
condition persists, contact the next
level of support.
Loopback plug(s) must be
installed on ports being
diagnosed. Press Next to
continue.
External loopback
diagnostics require an
optical loopback plug to
be installed.
Ensure that an optical loopback
plug is installed in port optical
transceiver before running external
wrap diagnostic testing.
Table 31 Element Manager messages (continued)
Message Description Action