HP StorageWorks 2.140 Director Switch - Manual (Page 231)

HA-Fabric Manager user guide 235
Cannot enable
beaconing while the
system light is on.
Occurs when choosing
Enable Beaconing option
for a failed FRU.
Replace FRU and enable
beaconing again or enable
beaconing on an operating FRU.
Cannot enable
beaconing while the
system error light is on.
Beaconing cannot be
enabled while the system
error light is on.
Select Clear System Error Light
from Product menu to clear error
light, then enable beaconing.
Cannot enable Open
Trunking while Enterprise
Fabric Mode is active and
the switch is offline.
Enterprise Fabric mode is
active and the switch or
director is online and you
attempted to enable
Open Trunking. This
message is displayed if
the optional Open
Trunking feature is
installed.
Perform either of the following
steps:
Disable Enterprise Fabric Mode
option by selecting the appropriate
fabric in the Fabric Tree portion of
the HAFM Manager window
(Fabrics tab) and then selecting
Enterprise Fabric Mode from the
Fabrics menu. When the Enterprise
Fabric Mode dialog box is
displayed, click Start and follow
prompts to disable the feature.
Set the switch or director offline
through the Set Online State dialog
box. Display this dialog box by
selecting Set Online State from the
Element Manager Maintenance
menu.
Cannot have E-Ports if
Management Style is
FICON unless SANtegrity
feature is installed. Please
contact your sales
representative.
Firmware is below the
required level and you
attempted to change
management style from
Open Systems to FICON
management style with
E_Ports configured, but
SANtegrity Binding is not
installed.
Informational message. If firmware
is below the required level and you
install SANtegrity Binding before
changing to FICON management
style, then E_Ports will remain as
E_Ports when you change to
FICON management style. If
SANtegrity Binding is not installed,
setting a director to FICON
management style will change all
E_Ports to G_Ports.
Cannot have spaces in
field.
Spaces are not allowed
as part of the entry for
this box.
Delete spaces from the box entry.
Cannot install firmware to
a director with a failed
CTP card.
A firmware version
cannot be installed on a
director with a failed
control processor (CTP)
card.
Replace the failed CTP card and
retry the firmware installation.
Table 31 Element Manager messages (continued)
Message Description Action