HP StorageWorks 2.140 Director Switch - Manual (Page 242)

Informational and error messages 246
Invalid management
server address.
The IP address specified
for the HAFM appliance
is unknown to the domain
name server (invalid).
Verify and enter a valid HAFM
appliance IP address.
Invalid network address. The IP address specified
for the product is
unknown to the domain
name server (invalid).
Verify and enter a valid product IP
address.
Invalid port address. Invalid port address has
been entered.
Verify port address through the
Configure Addresses–“Active”
dialog box (FICON management
style only) and reenter.
Invalid port number. The port number must be
within a range of ports for
the specific director or
switch model.
Enter a port number within the
correct range.
Invalid port swap. Port swap selection is not
allowed.
Ensure that each port selected for
swap has not been previously
swapped.
Invalid response received
from switch.
An error occurred at the
switch during a firmware
download operation.
Retry the firmware download
operation. If the problem persists,
contact the next level of support.
Invalid response received
from director.
An error occurred at the
director during a
firmware download
operation.
Retry the firmware download
operation. If the problem persists,
contact the next level of support.
Invalid serial number for
this feature key.
The serial number and the
feature key did not match.
Ensure that the feature key being
installed is specifically for this
director serial number.
Invalid UDP port number. The specified user
datagram protocol (UDP)
port number is invalid.
The number must be an
integer from 1 through
65535 inclusive.
Verify and enter a valid UDP port
number from 1 through 655535.
Invalid value for
BB_Credit.
At the Configure Fabric
Parameters dialog box,
the buffer-to-buffer credit
(BB_Credit) value must be
an integer from 1 through
60 inclusive.
Verify and enter a valid number
between 1 through 60.
Table 31 Element Manager messages (continued)
Message Description Action