HP StorageWorks 2.140 Director Switch - Manual (Page 246)

Informational and error messages 250
Performing this operation
will change the current
state to Offline.
This message requests
confirmation to set the
director offline.
Click OK to set the director offline
or click Cancel to cancel the
operation.
Performing this operation
will change the current
state to Online.
This message requests
confirmation to set the
director online.
Click OK to set the director online
or click Cancel to cancel the
operation.
Performing this action will
overwrite the date/time
on the switch.
Warning that occurs
when configuring the
date and time through the
Configure Date and Time
dialog box, that the new
time or date will overwrite
the existing time or date
set for the director or
switch.
Verify that you want to overwrite
the current date or time.
Periodic Date/Time
synchronization must be
cleared.
Action cannot be
performed because
Periodic Date/Time
Synchronization option is
active.
Click Periodic Date/Time
Synchronization check box in
Configure Date and Time dialog
box (Configure menu) to clear
check mark and disable periodic
date/time synchronization.
Port Binding was removed
from attached devices
that are also participating
in Switch Binding.
Informational message.
You removed Port Binding
from attached devices,
but one or more of these
devices is still controlled
by Fabric Binding.
Review the Switch Binding
Membership List to determine if the
devices should be members.
Port cannot swap to itself. Port addresses entered in
the Swap Ports dialog
box are the same.
Ensure that address in the first and
second Port Address boxes are
different.
Port diagnostics cannot
be performed on an
inactive port.
This is displayed when
port diagnostics is run on
a port in an inactive state.
Run the diagnostics on an active
port.
Port speeds cannot be
configured at a higher
rate than the director
speed.
This is displayed when
you configure a port to 2
Gb/sec and the director
speed is set to 1 Gb/sec.
Set the director speed to 2 Gb/sec
in the Configure Switch Parameter
dialog box.
Table 31 Element Manager messages (continued)
Message Description Action