HP LaserJet 5100 Printer series User Manual
Page 45
ENWW
Chapter 2: Printing Tasks
41
If the settings are not available from the software, set the custom
paper size from the control panel:
1 From the Printing Menu set
CONFIGURE CUSTOM PAPER=YES
.
2 From the Printing Menu, select inches or millimeters as the unit
of measurement.
3 From the Printing Menu, set the X dimension (the front edge of
the paper) as shown in Figure 13.The X dimension can be 3 to
12.28 inches (76 to 312 mm) for Tray 1. Set the Y dimension (the
side edge of the paper) as shown in Figure 13. The Y dimension
can be 5 to 18.5 inches (127 to 470 mm) for Tray 1.
4 If custom paper is loaded into Tray 1 and
TRAY 1 MODE=CASSETTE
,
then set
TRAY 1 SIZE=CUSTOM
from the Paper Handling Menu in
the printer’s control panel. See “Customizing Tray 1 Operation” on
page 45.
5 In the software, select Custom as the paper size.
For example, if the custom paper is 8 by 10 inches (203 by 254 mm),
set X=8 inches and Y=10 inches (X=203 millimeters and Y=254
millimeters).