HP LaserJet 5100 Printer series - Manual (Page 90)

82 Chapter 4: Problem Solving
ENWW
PCL Font List
Use the font lists to see which fonts are currently installed in the
printer. (The font lists also show which fonts are resident on a flash
DIMM.)
To print a PCL font list:
1 Press [Menu] until INFORMATION MENU appears.
2 Press [Item] until PRINT PCL FONT LIST appears.
3 Press [Select] to print the font list.
The following describes the information that can be found on the
PCL font list:
•
Font gives the font names and samples.
•
Pitch/Point indicates the pitch or point size of the font.
•
Escape Sequence (a PCL programming command) is used to
select the designated font. (See the legend at the bottom of the
font list page.)
Note For step-by-step instructions on using printer commands to select
a font with DOS applications, see page D-7.
•
Font # is the number used to select fonts from the printer’s control
panel (not the software application). Do not confuse the font #
with the font ID, described below. The number indicates the DIMM
slot where the font is stored.
•
SOFT: Downloaded fonts, which stay resident in the printer until
other fonts are downloaded to replace them, or until the printer
is turned off.
•
INTERNAL: Fonts that permanently reside in the printer.
•
Font ID is the number you assign to soft fonts when you download
them through software.