HP LaserJet 5100 Printer series - Manual (Page 72)

64 Chapter 4: Problem Solving
ENWW
FLASH DEVICE
FAILURE The flash DIMM had a critical failure and no longer can be used.
Remove the flash DIMM and replace it with a new one.
FLASH FILE
OPERATION FAILED The requested operation could not be performed. You might have
attempted an illegal operation, such as trying to download a file to a
non-existent directory.
FLASH FILE
SYSTEM IS FULL Delete files from the flash DIMM or add another one. Download or
delete fonts. (See the software help for more information.)
FLASH IS
WRITE PROTECTED The flash DIMM is protected, and no new files can be written to it.
INSTALL TONER
CARTRIDGE The print cartridge has been removed and must be replaced for
printing to continue.
INSTALL TRAY x The printer is unable to print the current job, because the specified
tray (
x ) is open or not inserted correctly.
Re-insert the specified tray.
LOADING
PROGRAM <number>
alternates with
DO NOT POWER OFF
Programs and fonts can be stored on the printer’s file system. At
bootup time these entities are loaded into RAM. (These entities can
take a long time to load into RAM depending on the size and number
of entities being loaded.) The
<number> specifies a sequence
number indicating the current program being loaded.
MANUALLY FEED
[TYPE] [SIZE] Load the requested paper into Tray 1.
Press [Go] if the desired paper is already loaded in Tray 1.
Press [-Value+] to scroll through the available types and sizes. Press
[Select] to accept the alternate type or size.
MEMORY FULL
STORED DATA LOST There is no available memory in the printer. The current job might not
print correctly and some resources (such as downloaded fonts or
macros) might have been deleted.
You might want to add more memory to the printer (page C-1).
MEMORY SETTINGS
CHANGED The printer changed its memory settings because it did not have
enough memory to use the previous settings for I/O Buffering and
Resource Saving. This usually occurs after removing memory from
the printer, or adding a printer language.
You might want to change memory settings for I/O Buffering and
Resource Saving (although default settings are usually best) or add
more memory to the printer (page C-1).
Printer Messages (Continued)
Message Explanation or Recommended Action