HP Secure Key Manager - Manual (Page 144)

Figure 69 Viewing the User List section
The following table describes the components of the User List section.
Table 50 User List section components
Description Component
Displays the users in the group. Username
Click Add to add a user to the user list. Add
Click Delete to delete a user from the user list. Delete
LDAP Server Configuration
Lightweight Directory Access Protocol (LDAP) is a protocol that allows you to enable authentication
of your KMS Server based on a central directory of users, rather than the local users and groups
defined on each device. To use LDAP with the KMS Server, you need an LDAP server available such
as MS Active Directory, Netscape Directory Server or OpenLDAP. You should also be familiar with
the schema defined by that server.
NOTE:
If you set up the KMS Server to use LDAP for users and groups, those users and groups are
case-
insensitive. For example, a user ID of JohnSmith can also be used throughout the system as
johnsmith. This is different from most other parts of the system where upper and lower case are treated
differently.
Passwords for both local users and LDAP users must not contain the less than character (<).
The LDAP Server Configuration page of the Management Console describes the configuration of the
LDAP server and its schema.
This page contains the following sections:
• LDAP User Directory Properties
• LDAP Schema Properties
• LDAP Failover Server Properties
LDAP User Directory Properties
Use the LDAP User Directory Properties section to define the basic properties of the LDAP server.
Using the Management Console 144