HP Secure Key Manager - Manual (Page 304)

Network commands
edit ip authorization allowed – edit the IP authorization settings for a particular IP address.
NOTE:
The ip authorization allowed command requires that you provide the index number
of the IP address you want to edit, rather than the actual IP address itself. You might
find it helpful to use the show ip authorization allowed command to find the
appropriate index number.
hostname (config)# edit ip authorization allowed <1>
IP Address, Range, or Subnet [1.1.1.1]: 1.1.1.2
KMS Server [y]: y
Web Administration [n]:
SSH Administration [n]:
IP successfully saved.
Syntax
• ip authorization
• ip authorization allowed
• no ip authorization allowed
• show ip authorization
• show ip authorization allowed
Related com-
mand(s)
ethernet port – change the Network Interface Port Speed/Duplex settings.
hostname (config)# ethernet port
fletch (config)# ethernet port
Enter the port speed and duplex for Ethernet #1:
1: Auto-Negotiate
2: 10 Mbps/Half Duplex
3: 10 Mbps/Full Duplex
4: 100 Mbps/Half Duplex
5: 100 Mbps/Full Duplex
Syntax
• show ethernet port
Related com-
mand(s)
gateway – define the default gateway to be used by the SKM.
hostname (config)# gateway <gateway IP> <interface #>
For example, you might enter the following:
hostname (config)# gateway 192.10.10.10 1
Syntax
• show gateway
• no gateway
Related com-
mand(s)
ip address – add an IP address, subnet mask, and interface number to the network settings of the SKM.
Using the Command Line Interface 304