HP Secure Key Manager - Manual (Page 35)

3. With the appliance fully seated in the rack, tighten the thumbscrews just until the bezel is secured
to the rack.
Attaching the cables
1. Connect a standard Ethernet (CAT-5) cable from your local IP network (LAN) to the 10/100/1000
NIC 1 (RJ-45) connector.
WARNING!
To reduce the risk of electric shock, fire, or damage to the equipment, do not
plug telephone or telecommunications connectors into RJ-45 (NIC) connectors.
2. Connect the appliance power supplies' AC power connectors to two separate AC power sources
using the power cables provided (see
Figure 2 ).
Figure 2 Connect the power supplies to AC power sources
3. Use the strain relief clip from the hardware kit to secure the power cord to the rack.
4. If this is a replacement appliance, pack the old appliance in the shipping materials for the
replacement appliance. You may need to remove the slide rails and null modem cable from the
old appliance to fit it in the box.
5. Plug one end of the null modem cable into the serial port. Plug the other end into the laptop or
PC that you will use to configure the appliance.
Secure Key Manager 35