HP Secure Key Manager - Manual (Page 179)

Description Component
Displays the result and timestamp for each of the following self-tests:
• AES Encryption
• DES Encryption
• DSA Encryption
• HMAC Algorithm
• SHA-1 Algorithm
• SHA2–256 Algorithm
• SHA2–384 Algorithm
• SHA2–512 Algorithm
• RSA Encryption
• X9.31 PRNG
• Continuous Random Number Generation
• RSA Pairwise Consistency
• DSA Pairwise Consistency
• Software Integrity
Test Results
If the device enters an error state, reboot. If the error persists, contact customer support.
FIPS Status Server page
The FIPS Status Server page enables you to manage the FIPS status server. The FIPS status server
monitors for FIPS-related status and error messages. If the device self-test fails upon start-up, all other
services on the device shutdown, including the Management Console. Only the FIPS status server
continues to run in this state.
This page contains the following section:
• FIPS Status Server Settings
FIPS Status Server Settings
Use this section to enable the FIPS Status Server and select the IP and port used to access the status
report.
Figure 97 Viewing the FIPS Status Server Settings section
The following table describes the components of the FIPS Status Server Settings section.
Table 78 FIPS Status Server Settings section components
Description Component
Select this option to enable the FIPS Status Server on this device. This requires the
Security ACL. Enable FIPS Status
Server
Secure Key Manager 179