HP Latex 210 Printer - Manual (Page 17)

2 Connectivity and software
instructions
Connection method
Your printer can be connected in the following way.
Connection type Speed Maximum cable length Other factors
Gigabit Ethernet Fast; varies according to
network traffic Long (100 m=328 ft) Requires extra equipment
(switches)
NOTE: The speed of any network connection depends on all the components that are used in the
network, which can include network interface cards, hubs, routers, switches, and cables. If any one of
these components cannot operate at high speed, you will have a low-speed connection. The speed of
your network connection can also be affected by the total amount of traffic from other devices on the
network.
Connect to a network
Before you begin, check your equipment:
● The printer should be set up and turned on.
● The Gigabit switch or router should be on and functioning correctly.
● All computers on the network should be turned on and connected to the network.
● The printer should be connected to the switch.
When the printer is connected to the network and turned on, you should see the printer's IP address
appear on the front panel (192.168.1.1 in this example). Make a note of the IP address: you can use it
later to access the Embedded Web Server.
ENWW Connection method 13
Connectivity