HP Latex 210 Printer - Manual (Page 20)

Request e-mail notification of specific error conditions
1. In the Embedded Web Server, go to the E-mail server page on the Setup tab and ensure that the
following fields are correctly filled in:
● SMTP server. This is the IP address of the outgoing mail server (Simple Mail Transfer
Protocol [SMTP]) that processes all e-mail messages from the printer. If the mail server
requires authentication, e-mail notifications will not work.
● Printer e-mail address. Each e-mail message that the printer sends must include a return
address. This address does not need to be a real, functional e-mail address, but it should be
unique, so that recipients of the message can identify the printer that sent it
2. Go to the Notification page, which is also on the Setup tab.
3. Click the New icon to request new notifications, or click the Edit icon to edit notifications that
have already been set up. Then specify the e-mail addresses to which notifications are sent, and
select the incidents that result in notification messages.
Change the cool-down delay
When there are no more jobs to print, the printer's drying and curing heaters remain on for a while, in
case another job arrives. To choose how long they remain switched on in this situation, go to the front
panel and select the icon, then Substrate handling options > Cooldown wait when idle.
Select a time from 5 to 60 minutes, then press the
OK button.
Change the sleep mode setting
If the printer is left turned on but unused for a certain period of time, it automatically goes into sleep
mode to save power. The default period of time it waits is 30 minutes. To change the time the printer
waits before it goes into sleep mode, go to the front panel and select the icon, then select Front
panel options > Sleep mode wait time. Highlight the wait time that you want, then press the
OK
button.
Turn the buzzer on or off
To turn the printer's buzzer on or off, go to the front panel and select the icon, then Audio alert,
then on or off. By default, the buzzer is on.
Change the front panel display contrast
To change the contrast of the front-panel display, select the icon, then Front panel options >
Select display contrast, then select a value by using the
Up or Down button. Press the OK button to
save the value.
Change the units of measurement
To change the units of measurement that appear on the front panel, select the icon, then Front
panel options > Select units, then English or Metric.
The units of measurement can also be changed in the Embedded Web Server.
16 Chapter 3 Basic setup options ENWW
Basic setu
p options