HP Latex 210 Printer - Manual (Page 46)

5. Remove the right-hand end of the take-up reel spindle, then the left.
NOTE: The take-up reel spindle is longer than the input spindle: the two are not
interchangeable.
6. Lift the lever to remove one of the stops from the spindle.
7. Load the core onto the take-up reel spindle. The width of the core should be the same as the width
of the substrate, so that the stops at each end can be correctly placed up against the substrate.
42 Chapter 4 Handle the substrate ENWW
Handle the substrate