HP Latex 210 Printer - Manual (Page 47)

8. Ensure that both stops are placed on the spindle, but leave some space between the core and the
stops at each end.
9. Load the take-up reel spindle into the printer by pushing firmly on both ends of the spindle.
10. Press the OK button on the front panel.
Advance the substrate using the arrows on the front panel. Make sure that the substrate passes in
front of the loading table, as shown.
11. Pull down the center of the substrate's leading edge to straighten the substrate. Do not attempt to
pull more substrate out of the printer.
NOTE: If you are loading the take-up reel during printing you do not need to pull the substrate
taut. Tape the substrate to the spindle core when an adequate length of substrate has fed from the
printer after printing begins.
12. Adjust the position of the core on the take-up reel spindle so that it is aligned with the substrate.
ENWW The take-up reel 43
Handle the substrate